replace PHE Spare Gasket for Reheat UFX118

Gasketed Plate Heat Exchanger, Plate Heat Exchanger, Plate Heat Exchangers PHE plates/gaskets are non-OEM, 100% compatible with genuine parts.

All PHE Gaskets and Plates are produced under approved production conditions, and both Rubber compounds and Plate material are analyzed on a third-party lab. Entrance material-control for Plates and gaskets is made at our own lab, to ensure compliance with certificates.

Heat exchangers of the plate type, plate heat exchanger, Plate Type Heat Exchanger

It is composed of concave convex stainless steel plates formed by stamping. The concave and convex patterns between the two adjacent plates form a 180 degree relative combination, so the concave and convex ridges between the two plates of the plate heat exchanger form staggered contact points. After the contact points are combined by vacuum welding, a high-pressure resistant staggered flow structure of the plate heat exchanger is formed. These staggered flow structures cause strong turbulence of the cold and hot fluids inside the plate heat exchanger, achieving high heat transfer efficiency. A plate heat exchanger is composed of a set of corrugated metal plates with four corner holes for the passage of two types of liquid for heat transfer. The metal plate is installed in a frame with a fixed plate and a movable compression plate on the side, and is clamped with clamping bolts. The plates are equipped with sealing gaskets to seal the fluid channels and guide the fluid to flow alternately into their respective channels, forming heat exchange. The flow rate, physical properties, pressure drop, and temperature difference of the fluid determine the number and size of the plates. The corrugated plate not only increases the level of turbulence, but also forms many support points that are sufficient to withstand the pressure difference between the media. The metal plate and movable plate pressing plate are suspended on the upper guide rod and positioned by the lower guide rod, while the rod end is fixed on the support column.